|
|
 
For Microsoft Windows NT follow the
steps below in installing and configuring your dialup connection to
Web56.net:
For added convenience, Web56.Net has
added automatic installation and configuration
files for you to enjoy our website.
- Configuring dialup
networking for use with Web56.net.
1.
Configuring dialup networking for use with Web56.net.
Once you are sure that Dialup Networking has been
installed, perform the following steps to configure the program to dial
into Web56.Net:
- Double-click on My Computer
- Double-click on Dialup Networking
- If Dial-Up Networking is not
installed you will be asked to install it. Click on the Install
Button.
- After clicking Install, WindowsNT will
install the RAS service for you. You will then be asked to select a
RAS device. Choose your modem, or if you have not yet
installed a modem choose the install modem button to do so
now. Click OK when done.
- After clicking OK, you will be presented
with the Remote Access Setup screen. Highlight your modem and
click on the Configure button.
- On the Configure Port Usage screen,
select "Dial out only" from the options.
The click OK when you are done.
- This takes you back to the Remote Access
Setup screen. Now Click on the Network Button.
- Select only the TCP/IP
protocol. Click OK when done
- Now click on the Continue
button on the Remote Access Setup screen.
- Dial-Up Networking is now installed. Close
any programs you may be running and Restart you
computer.
- When your computer is finished rebooting
go back into "My Computer" and Click on Dial-Up
Networking.
- The first time you start Dial-Up
Networking you will see the following message, Click OK.
- Verify the settings
below.Click OK when you are done.
- Now select Dial from the Dial-Up Networking
screen to test the new connection.
- Fill out the following dialog with the correct information for your
account. Leave the Domain field blank. Choose
the "Save password" option is you wish your password to be
saved so you do not need to type it in again.
|
